|
 |
|
Engine Performance Programs
|
| ATech's Engine Performance programs are the heart of ATech's business - just as these systems are the heart of today's automobiles. |
|
|
|
|
Toyota OBD II System
Model 2671 / 80
These trainers offer “hands on” study of OBD II technology, with complete
powertrain control, OBD II monitors, new standard diagnostic features, and performance of the trip/drive cycle.
NO OTHER CLASSROOM TRAINERS OFFER THESE FEATURES.
■ Engine and Transmission Control (EFI/TCCS)
■ Includes Ignition System
■ Compatible with OBD II Scan Tools
■ Performs Toyota OBD II Drive Cycle
■ Enhanced Diagnostics with Code, No-Code, Ignition, OBD II, and Transmission Faults
■ Courseware Included |
Toyota OBD II
Fault Panel
 |
|
|
GM OBD II System
Model 2651 / 60
These trainers offer “hands on” study of OBD II technology, with complete
powertrain control, OBD II monitors, new standard diagnostic features, and performance of the trip/drive cycle.
NO OTHER CLASSROOM TRAINERS OFFER THESE FEATURES.
■ Engine and Transmission Control
■ Compatible with OBD II Scan Tools
■ Performs GM OBD II Drive Cycle
■ Enhanced Diagnostics with Code, Engine Protection, and OBD II Faults
■ Interface with C3I Ignition (Model 1771F)
■ Courseware Included |
GM OBD II Fault Panel
 |
|
|
EEC-V System
Model 1671 / 80
This Trainer offers a “hands on” study of OBD II technology, with complete Powertrain Control, OBD II monitors, new standard diagnostic features, and performance of the trip/drive cycle.
■ Developed with Ford
■ Used in Ford Training Centers
■ Engine and Transmission Control
■ Compatible with OBD II Scan Tools
■ Enhanced Diagnostics with Code, No-Code, OBD II, and Intermittent Faults
■ Interface with Ford EDIS-V (Model 1791F)
■ Courseware Included |
EEC-V Fault Panel
 |
|
|
Universal "On-Vehicle" Fault Insertion
Model 2110
■ Hard and Intermittent Faults
■ Open/High Resistance/Short
■ Optional Remote Control
■ Low Cost
|
|
GM OBD II (Suitcase) System
Model 2651 / 60S
■ Engine and Transmission Control
■ Compatible with OBD II Scan Tools
■ Enhanced Diagnostics with Code, Engine Protection, and OBD II Faults
■ Interface with Suitcase C3I Ignition (Model 1771SF)
■ Courseware Included
■ Trainer Size: 30 x 20 x 10 inches
■ Trainer Weight: 40 pounds |
Fault Panel
 |
Fuel Injector Waveform Measurement
Oxygen Sensors and Fuel Trim Control
Fuel Control Oxygen Sensor Signal
 |
OBDII Monitor Status
 |
|
GM OBD (Suitcase) Full Front Panel View
|
Transaxle Control:
• Realistic electronic control of shift solenoids
• Realistic up-shifting based on vehicle speed, gear selection, & throttle position
• Realistic Torque Converter Clutch solenoid operation including apply / release & rate control solenoids
• Downshift during Full Throttle
• Realistic manual downshifting
• Realistic coast-down downshift
Engine Control:
• Actual emission control operation based on sensor inputs
• Actual sequential injector operation
• Flooded engine clearing during start-up
• RPM increase during A/C Demand
• Knock retard of spark (observable on scan tool)
• Low temperature “choke” action
• Actual engine load operation
• High speed injector cut-out
• Fuel Trim Control
• Ignition control signals (C3I Demonstrator)
• Ignition sensor signals (C3I Demonstrator)
OBD II Demonstrations:
• Performs GM OBD II Drive Cycle
• Normal Catalytic Converter Monitoring System Operation
• Failed Catalytic Converter Monitoring System Operation
• Normal Closed Loop Fuel Control Oxygen Sensor Oper.
• Slow Response Rate Fuel Control Oxygen Sensor Oper.
• Normal Oxygen Sensor Warm-up Operation
• Normal Oxygen Sensor Heater Monitor Operation
• Shift in A/T Ratio Control Point
• Normal Short Term/Long Term Fuel Trim Operation
• Normal EGR Monitor Operation
• No Feedback EGR Operation
• Type “A” CAT Converter Damage Misfire
• Normal Comprehensive Component Monitoring
• Selected failure of Comprehensive Component Monitoring
• Normal Evaporative System Monitor Operation
• Catalytic Converter “Warm-up” Operation
• Catalytic Converter “Punch Through” Operation
|
GM OBS II Trainer connected to C3I Ignition Trainer
|
GM OBS II System (Dry)
Model 2651 / 60DRY
Dry Option Panel
Trainer Options:
■ Optional Floor Model Legs - Model TFM
■ Fuel Injection and Ignition Trainer Interface:
(Required for connection of ignition system to fuel injection trainer)
• Ford EEC V – Ford EDIS V Cable – Model 1677
• GM OBD II – GM C3I Cable – Model 2657
• GM OBD II(Suitcase) – GM C3I (Suitcase) Cable – Model 2657S
■ Dry Option: Simulated fuel injection/pump
•Toyota OBD II (DRY) - Model 2671/80 DRY
•GM OBD II (DRY) - Model 2651/60 DRY
•Ford EEC-V (DRY) - Model 1671/80 DRY
Optional Floor Model Legs - Model TFM:
|
|
|
|
|
|
Continue to Page 2 |
|
To receive more detailed information about our Automotive Training programs or any other products offered by our Technical Education division, please contact a member of our sales staff.
|
